The DCR 3 Rotating head tank is equipped with Dual coils that deliver a smooth yet powerful Vape.
The top of the tank commonly known as the drip tip or mouth piece is mounted on an ingenious swivel head device that allows you to adjust the angle of the drip tip/mouth piece to a comfortable position.
The DCR3 has plenty of capacity at 3.0ml of liquid and is ideally suited to all Variable Voltage MOD Batteries equipped with 510 size threading.
To get the best out of DCR 3 we would recommend an operating voltage of between 3.2 to 3.9 volts (dependent on the resistance of the coil selected).
In the accessories section replacement coils are also available we offer 2 sizes: either 1.8 to 2.0 ohm or 2.2 to 2.4ohm.
The DCR3 is filled with liquid from the top of the tank not the bottom.
Remove the tank top as follows:
Grip the plastic tank body and the serrated tank top cover and turn the tank top cover Anti- Clockwise. Prior to filling with liquid make sure the plastic body of the tank is fully screwed and reasonably tight in to the tank bottom otherwise the tank may leak. (Do not over tighten)
Enter the Needle bottle or e liquid bottle in to the top of the plastic tank. Hold the tank at an angle of approximately 30 degrees and slowly drizzle liquid down the inside wall of the tank. Do not overfill above the 3.0ml mark indicated on the side of the tank. Do not pour liquid down the tube located in the centre of the tank as this is the airway. When the tank is full to the 3.0ml mark firmly screw the tank top back on to the tank body clockwise. (Do not over tighten).
On first filling the tank we highly recommend that the tank is left with the liquid inside for at least 1 hour prior to using the tank, this allows the multi wick and coil to become properly saturated. This action will lead to a better all-round vape and also extend the life of the atomizer coil.
To change the Atomizer coil:
Ensure that the tank is empty and wear protective surgical gloves.
Unscrew the tank top as described above and set aside.
Unscrew the tank bottom and set aside the plastic tank body, note: You can wash the plastic tank body in clean cold water if you wish to: NEVER WASH THE TANK WORKINGS.
Connected to the tank base you will see the wick and coil head on top of a stainless steel shaft. Grip the stainless steel shaft at the bottom of the shaft and rotate anticlockwise to remove the coil head wicks and shaft. Replace with the new coil head wick and shaft by screwing the shaft on to the base of the tank clockwise: ensure that this connection is reasonably tight.
Replace the plastic tank body (check to ensure the tank body is not upside down check the tank scale is the correct way round) over the wick shaft and screw to the tank base: ensure that this connection is reasonably tight but do not over tighten.
Fill with liquid as described above and replace the tank top.
Leave to stand for one hour to enable the wicks to become saturated prior to use.
The DCR3 specification is as follows:
• Capacity: 3.0mL
• Resistance: 1.8ohm to 2.4ohm
• Length: 76mm
• Diameter: 19mm
• Empty weight: 40 grams
• Thread: 510
• Coils: Replaceable dual coils in 1.8 to 2.2ohm or 2.2 to 2.4ohm
• Drip tips: Rotatable mouth piece
• Colour options: Clear or black
Please select your E-Liquid Flavour
© E. Smoking Products Limited 2016
Creative Web Design by Prototype Creative